Martin boots attracted many friends to buy because of their fashionable and beautiful appearance, but there will be some problems in the wearing process, which caused a little trouble. For example, what if the laces of Martin boots are too long? How to tie the laces of Martin boots? Martin boots' shoelaces are too long, which can be solved by tying an extra knot, hiding the shoelaces, or tying the shoelaces into various patterns. Here are some ways to tie Martin boots' shoelaces. I hope you like them.
1、 How to tie the laces of Martin boots if they are too long
If the laces of Martin boots are too long, it is very simple. As long as you tie a knot when tying the laces, you can easily remove the excess laces. However, this comparison applies to a little more shoelaces, but it is not very exaggerated. If it is the kind of super long shoelaces, you can choose to hide the shoelaces in the shoes. Or you can also use the following pattern shoelace method.
2、 How to tie the laces of Martin boots
Crisscross knot
1. One end is knotted inside, and the other end is perforated in sequence;
2. Jump a hole into it and tie it down in the same way;
3. After repetition, the remaining shoelaces are stuffed into the inner side and knotted;
4. Another kind of color shoelaces are also perforated in the same way, from below, and then from above;
5. Choose the harmonious shoelaces according to the color of Martin boots, and tie the excess shoelaces on the inside.
Trapezoidal junction
1. After adjusting the length of both ends of the shoelace, pull out the shoelace from inside to outside;
2. Pull out the shoelaces and put them into the second hole from the outside to the inside;
3. The shoelace on the left comes out from under the shoelace between the two holes on the right, which is the same on the right;
4. Repeat the operation and pay attention to the cross laces at both ends;
5. The excess shoelaces are stuffed into the shoes and knotted, and the trapezoidal knot is completed.
Fried dough twist knot
1. Two shoelaces are knotted inside and put out;
2. The two laces of Martin boots cross and come out of the second hole;
3. At this time, in order to center the intersection as much as possible, tighten the shoelace;
4. The appearance of fried dough twist occurs in the process of centering the intersection;
5. Leave the last hole, and finally use X to cross knot, so it is more convenient to wear and take off;
Double x junction
1. Starting from the second hole, pass through the shoelace from the outside to the inside;
2. Use x-knot method to tie white shoelaces first, plug the end to the inside and then knot;
3. Take the second shoelace through the first hole, tie an X knot, and pass through the intersection of white shoelaces;
4. Knot the end of the shoelace, and the remaining lines are relatively long, so you can make a ring;
5. Go through the ring after a few rounds.
Diagonal knot
1. First, choose blue and white laces;
2. After passing through the first hole, make a single knot inside, and the other end passes through the third hole on the left from inside to outside;
3. The laces of Martin boots are then threaded through the second hole on the right, and the diagonal knot is completed with the blue laces;
4. Use white shoelaces to tie diagonal knots in the opposite direction in the same way as blue shoelaces;
5. The blue and white shoelaces finally come out of the hole of the tongue, and it's better to tie them loosely.
